Experiment with Op-Amps as summing/differential amplifiers. Change the gain or use the unique capability to sum several signals without coupling them together. As a member of the Blox product line, the resistors are changeable while maintaining good electrical conductivity and layout, no more trying to work around the restrictions of a solderless breadboard. For those looking for a more permanent electronic building block a touch of solder and the assembly is ready to be included in your next DIY project.
Can be used with split supply or single supply due to biasing jumper and active reference.
The Blox system is somewhat unique in in that it is an electronic prototyping system suited to analog circuits. Utilizing high quality machined terminal sockets the resistors may be changed and experimented with without all of the parasitics and disadvantages of a standard solderless breadboard. When a final selection is made the resistor can then be permanently soldered eliminating long term effects of heat, vibration and other environmental factors… its the best of both worlds for prototyping and permanent installation.
As of the recent release the Differential Summing Amplifier now has a choice for the “GND” reference used when summing. The second OpAmp is used to create a 1/2 VCC reference with low impedance or else the standard VSS/GND can be selected for single supply, and also a dedicated VSS on the 3rd pin of the power connector.
This product is sold as a kit of easily solderable through-hole components and includes the power cable and standoffs.
Differential Summing OpAmp Amplifier
From Wikipedia: A differential summing OpAmp amplifier is a type of electronic amplifier that amplifies the difference between two input voltages but suppresses any voltage common to the two inputs.[1] It is an analog circuit with two inputs and and one output in which the output is ideally proportional to the difference between the two voltages:

where A is the gain of the amplifier.
More information can be found at https://en.wikipedia.org/wiki/Differential_amplifier
OPAmp Performance
- Dual Opamp version of the LM358, LM324, LM2904
- Single Supply: 3 V to 32 V
- Dual Supplies: ±1.5 V to ±16 V
- Slew Rate (Typ) (V/us): 0.3 V/us
- GBW (Typ) (MHz): 0.7 MHz
- Vos (Offset Voltage @ 25C) (Max) (mV): 7 mV
- Operating Temperature Range (C): 0-70 C
- Offset Drift (Typ) (uV/C): 7 uV/C

Reviews
There are no reviews yet.